
Page 9 of 69
Time adjustment
TIME STAMP IS A VERY IMPORTANT REFERENCE FOR RECORDING AND SEARCHING.
PLEASE, SET CLOCK CORRECTLY AFTER READING THIS SECTION.
Step 1. Set GMT/Location
Since DST rule is different location by location, you must set your correct location.
Please, set correct GMT/Location in Admin / DateTime menu.
Refer to “Daylight Saving Time” section in Chapter 2.
Refer to “Admin / DateTime” menu in Chapter 5.
Step 2. Initial time synchronization in Admin menu (Optional)
If the unit can access network time server, it is recommended strongly to synchronize the time with
the network time server before start, in Service menu.
If the time difference is big, then time synchronization is failed in recording mode.
You can do this job in Admin / DateTime menu.
Refer to Admin / DateTime menu in Chapter 5.
Step 3. Time adjustment
If you are unable to do step 2, then you need to adjust the time manually.
Refer to Admin / DateTime menu in Chapter 5.
Step 4. Periodical time synchronization
(Optional)
You can configure the unit to synchronize the time periodically with network time server.
Refer to System / TimeSync menu in Chapter 4.
Komentáře k této Příručce